Join the Blanchard Team..
Apply Now
Maximum Rating100 ekW
Minimum Rating100 ekW
Emissions/Fuel StrategyU.S. EPA Cert., Tier 3
Voltage208 to 600 Volts
Frequency60 Hz
Speed1800 rpm
Duty CycleStandby
Engine ModelC4.4, In-line 4, 4-cycle diesel
Bore4.1in
Stroke5in
Displacement269in³
Compression Ratio16.7:1
AspirationTurbocharged
Fuel SystemCommon Rail
Governor TypeMechanical, ADEM™A4
Length - Maximum82.6in
Width - Maximum43.3in
Height - Maximum52.9in
Dry Weight - Genset (maximum)2222lb
Standard
Air cleaner; light duty with disposable element
Air cleaner
Standard
Coolant drain line with valve
Radiator and cooling fan with guards
Caterpillar extended life coolant
Fan drive, battery charging alternator drive
Optional
Coolant heater
Low coolant temperature alarm
Low coolant level shutdown
Standard
GCCP 1.2 Control panel
Standard
Stub pipe, gaskets, raincap and SAE exhaust flange for customer use - shipped loose
Standard
Standard open set fuel tank/base supplied base, formed steel with single wall integral 24-hour fuel tank
Optional
Low fuel level alarm
Bunded fuel tank
Low fuel level shutdown
High fuel level alarm
Standard
Circuit breaker, IEC, 3 pole, mounted in tower panel
IP23 Protection
Tower panel, IP22, bottom cable entry
12 Leads
Voltage regulator (single phase sensing)
Segregated low voltage (AC/DC) wiring panel
Standard
Mechanical and electrical governing system - model dependent
Standard
Lubricating oil
Oil drain line with valve
Standard
Termination points for coolant and lube oil drain lines
Captive linear vibration isolators between base and engine-generator
Includes lifting provision and drag points
Standard
Batteries
24V battery with rack and cables
Standard
Engine and alternator pre-paint, Caterpillar yellow
Optional
Anti-condensation heater
3 phase sensing
Permanent magnet excitation (PMG)
R Frame auxilliary winding
Quadrature droop kit
Optional
Circuit breaker upgrades - 4 Pole circuit reaker to 250A, 400A and 630 A
Optional
Earth fault (2 wire only)
Control panel heater
GCCP 1.2 Control panel
Volt free contacts
Emergency stop with key
Voltage adjust potentiometer
Overload shutdown via breaker
Panel mounted audible alarm
Battery charger
Earth leakage (2 wire only)
Speed adjust potentiometer
Optional
Sound attenuated Level 2 enclosure
Optional
Battery removal
Electronic governor
Industrial silencer
External single point lift - enclosure
Silencer installation kit
Optional
PGS Test report @ 0.8 power factor
PGS Test report @ 1.0 power factor
Optional
Packing case - canopied set
Packing case - compact set
Stone guards/rad trans flange
Complete this form to get a quote on the equipment you are interested in.
