C4.4 Generator Set

Caterpillar is leading the power generation marketplace with Power Solutions engineered to deliver unmatched flexibility, expandability, reliability, and cost-effectiveness.

Request a Quote

Maximum Rating100 ekW

Minimum Rating36 ekW

Emissions/Fuel StrategyNon Regulated, EU Stage II

Voltage220 to 480 Volts

Frequency60 Hz

Speed1800 rpm

Duty CycleStandby, Prime

Engine ModelC4.4, In-line 4, 4-cycle diesel

Bore4.13in

Stroke5in

Displacement268.5in

Compression Ratio18.2:1

AspirationTurbocharged

Fuel SystemElectronic (adjustable)

Governor TypeAdem™A4

Length - Maximum75.8in

Width - Maximum44.1in

Height - Maximum53.6in

Standard

Air cleaner; light duty with disposable element

Standard

Air cleaner

Standard

Package mounted radiator

Standard

Fan drive, battery charging alternator drive

Radiator and cooling fan with guards

Coolant drain line with valve

Caterpillar extended life coolant

Optional

Coolant heater

Low coolant level shutdown

Low coolant temperature alarm

Standard

Exhaust flange outlet

Optional

Industrial, residential, critical mufflers

Standard

GCCP 1.3

Standard

Stub pipe, gaskets, raincap and SAE exhaust flange for customer use - shipped loose

Standard

Standard open set fuel tank/base supplied base, formed steel with single wall integral 8-hour fuel tank

Optional

Compact skidbase for open set

Low fuel level alarm

Low fuel level shutdown

Bunded fuel tank

Open set narrow tankbase

Skidbase for CALG enclosure sets

High fuel level alarm

Standard

Secondary fuel filters

Primary fuel filter with integral water separator

Fuel priming pump

Standard

Segregated low voltage (AC/DC) wiring panel

Voltage regulator (single phase sensing)

Matched to the performance and output characteristics of Cat engines

12 Leads

Load adjustment module provides engine relief upon load impact and improves load acceptance and recovery time

Circuit breaker, IEC, 3 pole, mounted in tower panel

Tower panel, IP22, bottom cable entry

IP23 Protection

Optional

Excitation: [ ] Permanent magnet excitation (PMG) Excited (PM) [ ] Internally Excited (IE)

Oversize and premium generators

Anti-condensation heater

Standard

Mechanical and electrical governing system - model dependent

Standard

Lubricating oil

Oil drain line with valve

Standard

Busbar

Optional

Circuit breakers, IEC compliant

Circuit breakers, UL listed

Standard

Captive linear vibration isolators between base and engine-generator

Includes lifting provision and drag points

Termination points for coolant and lube oil drain lines

Standard

Rubber vibration isolators

Standard

24V battery with rack and cables

Standard

Paint - Caterpillar yellow except rails and radiators gloss black

Engine and alternator pre-paint, Caterpillar yellow

Optional

Single or dual wall sub-base fuel tanks

EU Certificate of Conformance (CE)

CSA Certification

Single or dual wall integral fuel tanks

Automatic transfer switches (ATS)

Narrow, wide or skid base

UL 2200 package

Seismic Certification per applicable building codes: IBC 2000, IBC 2003, IBC 2006, IBC 2009, CBC 2007

Sound attenuated, weather protective or high ambient weather protective enclosure

EEC Declaration of Conformity

Integral & sub-base fuel tanks

Standard

24 volt starting motor

Batteries

Optional

Jacket water heater

Charging alternator

Heavy duty starting system

Battery chargers

Oversize batteries

Optional

3 phase sensing

Permanent magnet excitation (PMG)

R Frame auxilliary winding

Quadrature droop kit

LC Frame alternator with coastal insulation protection

Optional

Circuit breaker upgrades - 4 Pole circuit reaker to 250A, 400A and 630 A

Optional

GCCP 1.3

Load share module

Digital I/O module

Remote monitoring software

Local & remote annunciator modules

Optional

Earth fault (2 wire only)

GCCP 1.3

Volt free contacts

Emergency stop with key

Battery charger

Panel mounted audible alarm

Control panel heater

Speed adjust potentiometer

Voltage adjust potentiometer

Earth leakage (2 wire only)

Overload shutdown via breaker

Optional

Sound attenuated Level 2 enclosure

Sound attenuated Level 1 (galv)

Rental pack - CAE rental option only

Optional

Upgrade to STD set for CE

Optional

Certification for CIS

Optional

Battery removal

Electronic governor

Industrial silencer

Silencer installation kit

External single point lift - enclosure

Optional

PGS Test report @ 1.0 power factor

PGS Test report @ 0.8 power factor

Optional

Packing case - compact set

Stone guards/rad trans flange

Packing case - canopied set

CONTACT US

REQUEST A QUOTE

Complete this form to get a quote on the equipment you are interested in.

    This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

    What You Get: A phone call from a rep or agent. A cost estimate for your machine or the project. An in-person consultation if necessary.