D100 GC Generator Set

D100 GC Generator Set

Caterpillar is leading the power generation marketplace with Power Solutions engineered to deliver unmatched flexibility, expandability, reliability, and cost-effectiveness.

Request a Quote

Maximum Rating100 ekW

Minimum Rating100 ekW

Emissions/Fuel StrategyU.S. EPA Cert., Tier 3

Voltage208 to 600 Volts

Frequency60 Hz

Speed1800 rpm

Duty CycleStandby

Engine ModelC4.4, In-line 4, 4-cycle diesel

Bore4.1in

Stroke5in

Displacement269in³

Compression Ratio16.7:1

AspirationTurbocharged

Fuel SystemCommon Rail

Governor TypeMechanical, ADEM™A4

Length - Maximum82.6in

Width - Maximum43.3in

Height - Maximum52.9in

Dry Weight - Genset (maximum)2222lb

Standard

Air cleaner; light duty with disposable element

Air cleaner

Standard

Coolant drain line with valve

Radiator and cooling fan with guards

Caterpillar extended life coolant

Fan drive, battery charging alternator drive

Optional

Coolant heater

Low coolant temperature alarm

Low coolant level shutdown

Standard

GCCP 1.2 Control panel

Standard

Stub pipe, gaskets, raincap and SAE exhaust flange for customer use - shipped loose

Standard

Standard open set fuel tank/base supplied base, formed steel with single wall integral 24-hour fuel tank

Optional

Low fuel level alarm

Bunded fuel tank

Low fuel level shutdown

High fuel level alarm

Standard

Circuit breaker, IEC, 3 pole, mounted in tower panel

IP23 Protection

Tower panel, IP22, bottom cable entry

12 Leads

Voltage regulator (single phase sensing)

Segregated low voltage (AC/DC) wiring panel

Standard

Mechanical and electrical governing system - model dependent

Standard

Lubricating oil

Oil drain line with valve

Standard

Termination points for coolant and lube oil drain lines

Captive linear vibration isolators between base and engine-generator

Includes lifting provision and drag points

Standard

Batteries

24V battery with rack and cables

Standard

Engine and alternator pre-paint, Caterpillar yellow

Optional

Anti-condensation heater

3 phase sensing

Permanent magnet excitation (PMG)

R Frame auxilliary winding

Quadrature droop kit

Optional

Circuit breaker upgrades - 4 Pole circuit reaker to 250A, 400A and 630 A

Optional

Earth fault (2 wire only)

Control panel heater

GCCP 1.2 Control panel

Volt free contacts

Emergency stop with key

Voltage adjust potentiometer

Overload shutdown via breaker

Panel mounted audible alarm

Battery charger

Earth leakage (2 wire only)

Speed adjust potentiometer

Optional

Sound attenuated Level 2 enclosure

Optional

Battery removal

Electronic governor

Industrial silencer

External single point lift - enclosure

Silencer installation kit

Optional

PGS Test report @ 0.8 power factor

PGS Test report @ 1.0 power factor

Optional

Packing case - canopied set

Packing case - compact set

Stone guards/rad trans flange

CONTACT US

REQUEST A QUOTE

Complete this form to get a quote on the equipment you are interested in.

    This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

    What You Get: A phone call from a rep or agent. A cost estimate for your machine or the project. An in-person consultation if necessary.