DE605 GC (50 Hz) Generator Set

DE605 GC (50 Hz) Generator Set

Caterpillar is leading the power generation marketplace with Power Solutions engineered to deliver unmatched flexibility, expandability, reliability, and cost-effectiveness.

Request a Quote

Maximum Rating605 kVA

Minimum Rating605 kVA

Emissions/Fuel StrategyNon Regulated

Voltage380 to 415 Volts

Frequency50 Hz

Speed1500 rpm

Duty CycleStandby

Engine ModelC15 In-line 6, 4-cycle diesel

Bore5.4in

Stroke6.8in

Displacement928in³

Compression Ratio16.1:1

AspirationTurbocharged Air-to-Air Aftercooled

Fuel SystemEUI

Governor TypeAdem™A4

Length - Maximum131in

Width - Maximum60.6in

Height - Maximum86.1in

Dry Weight - Genset (maximum)8120lb

Standard

Cat® C15 Inline 6 Cylinder, 4 Stroke Diesel

Standard

GCCP 1.1

Standard

Air Cleaner

Standard

Mechanical Governor

Standard

A Frame Standard Alternator

Optional

Space Heater

AVR

Standard

Package mounted radiator

Standard

Single Wall 8 Hour Tank

Standard

Caterpillar Extended Life Coolant

Radiator and cooling fan with guards

Fan drive, battery charging alternator drive

Standard

3 Pole Circuit Breaker

Neutral Earth Link

24 Volt battery with rack and cables

Optional

4 Pole circuit breaker

Auxiliary Contacts

Pad-lockable circuit breaker

Battery Charger

Wet Battery

Standard

Secondary fuel filter

Fuel priming pump

Primary fuel filter with integral water separator

Standard

Air cleaner; light duty with disposable element

Optional

Single Stage Air Filter

Dual Element Air Filter

Standard

IP23 Protection

Matched to the performance and output characteristics of Cat engines

Load adjustment module provides engine relief upon load impact and improves load acceptance and recovery time

Optional

Anti-condensation heater

Excitation: [ ] Permanent Magnet Excited (PM) [ ] Internally Excited (IE)

Oversize and premium generators

Standard

Lubricating oil

Oil drain line with valve

Standard

Captive linear vibration isolators

Lifting provision and drag points

Standard

Engine and alternator pre paint, Caterpillar yellow

Engine and alternator pre paint, Caterpillar yellow

Optional

Automatic transfer switches (ATS)

EEC Declaration of Conformity

Integral & sub-base UL listed dual wall fuel tanks

Single or dual wall sub-base fuel tanks

Seismic Certification per applicable building codes: IBC 2000, IBC 2003, IBC 2006, IBC 2009, CBC 2007

CSA Certification

UL 2200 package

The following options are based on regional and product configuration:

Single or dual wall integral fuel tanks

EU Certificate of Conformance (CE)

Sound attenuated, weather protective or high ambient weather protective enclosure

Narrow, Wide or Skid Base

Standard

Bus Bar

Optional

Circuit breakers, IEC compliant

Circuit breakers, UL listed

Standard

Power center, IP22

Segregated low voltage (AC/DC) wiring panel

Mandatory Option circuit breaker, IEC, 3 pole, mounted in power centre

Optional

Oversize A frame generator

LC frame CIP generator

Permanent magnet generator

Space heaters

Ingress protection

LC frame generator

A frame generator - IP21 Protection

CIP a frame generator

Oversize LC frame generator

Standard

Rubber vibration isolators

Standard

Cat Electronic Governor (ADEM A4).

Standard

Oil cooler

Oil drain valves

Optional

Manual sump pump

Standard

Captive linear vibration isolators between base and engine-generator includes lifting provisions and termination points for coolant and lube oil drain lines

Optional

Narrow skid base - replaces standard fuel tank base

Optional

Industrial, Residential, Critical Mufflers

Optional

Speed and Voltage Adjust Potentiometers

PLG 4G/3G/Ethernet

Annunciator

Emergency E-Stop

Optional

Cat GC Enclosure

Optional

Dual Wall 8Hr Fuel Tank

Single Wall 8Hr Fuel Tank with Spill Containment

Low Fuel Level Shutdown

Low and High Fuel Level Alarms

Manual fuel transfer pump

Fuel transfer system controls

Dual wall fuel tank base

Optional

Charging alternator

Jacket water heater

Battery chargers

Oversize batteries

Heavy-duty starting system

24 Volt battery with rack and cables

Optional

EU certificate of conformance

EAC certification

Optional

3, 4, 5 and 10 Years

Optional

High ambient sound attenuated enclosures

Optional

Industrial Silencer

10 dBA Attenuation silencer

Manifold and turbocharger guard

End in / End out mufflers - 10, 25 and 35 dBA attenuation

Flexible exhaust fittings

6 and 8 inch elbow kit

6 and 8 inch flange GP

Engine mounted muffler

Optional

PGS Test report @ 1.0 power factor

PGS Test report @ 0.8 power factor

Optional

5 Amp single battery charger

Battery disconnect switch

Jacket water heater

CONTACT US

REQUEST A QUOTE

Complete this form to get a quote on the equipment you are interested in.

    This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

    What You Get: A phone call from a rep or agent. A cost estimate for your machine or the project. An in-person consultation if necessary.